5
SUPERCOOL-1000 rev.03
SUPERCOOL-1000
FEATURES2.
The SUPERCOOL-1000 is an electronic device
used to control the humidity level and room
temperature in livestock buildings. It allows
the user to cool the building and maintain a
specified humidity level by operating venti-
lation and mist cooling equipment. It can
control one mist cooling zone and three fan
stages. The main features of the SUPER-
COOL-1000 are as follows:
Large LCD Display — The large LCD display
gives the current readings and displays the
parameters. Refer to the next section of this
manual for further information about the pa-
rameters that are shown on this display.
P i l ot L i g h ts — Pilot lights indicating the state
of outputs allow the user to monitor the
operation of the system without having to
enter the building.
Removable Connectors — The inputs' con-
nection is now made easier by removing the
connectors from the main board.
Manual Control — The mist cooling valve
and pump can be manually activated using a
switch located on the side of the controller.
Dust Control Cycle — When mist units are
not required for reducing room temperature,
they can be operated either continuously or
intermittently to reduce the level of dust in
the room.
Humidity Compensation — Operating times
for mist timers can be automatically adjusted
as a function of humidity levels in the build-
ing.
Probe Inputs — Up to 6 temperature probes,
1 outside temperature probe and 3 humidity
sensors can be connected to the controller
in order to obtain a more accurate reading of
the average room temperature and humidity
level.
Probe Readings Recorded For Past Days —
Minimum and maximum readings from tem-
perature and humidity probes are recorded for
the current day and the past six days.
Monitoring Of Water Consumption — A
pulse input is available to monitor daily wa-
ter consumption for the current day and the
past six days.
Maintenance Reminder Function — A mes-
sage reminding the user to perform pump
maintenance can be signalled after the pump
has been in operation for a specified time.
Alarm Management — Alarms are provided
for defective probes and other system func-
tions. Alarm states are kept in memory until
acknowledged even if an alarm situation has
been rectified.
Password Protection — A password feature
can be enabled to restrict access to the con-
troller setup functions.
Backup Battery — A backup battery allows
the unit to keep time in case of a power
failure.
Overload And Overvoltage Protection — Re-
settable fuses are provided at low-voltage
inputs and outputs of the controller to pro-
tect its circuitry in the case of an overload
or overvoltage.
Computer Control — The controller can be
connected to a computer, thus making it
possible to centralize the management of
information and diversify control strategies.
Test Mode — A test mode allows you to
simulate temperature changes and verify
controller performance.
To Next Page
Loading...