Why is the alarm LED continuously lit on my SECO-LARM SLI Enforcer E-964-D390Q?
If the Alarm LED on your SECO-LARM Security Sensors is continuously lit, it could be due to several reasons: the lenses might be out of alignment, the beams could be blocked, or the cover might be foggy or dirty. Try these solutions: * Realign the lenses. * Remove any obstacles blocking the beams. * Clean the cover.
What to do if SECO-LARM Security Sensors have frequent false triggers?
If your SECO-LARM Security Sensors are experiencing frequent false triggers due to leaves, birds, or other small objects, it could be because the sensors are too sensitive or the location is not ideal. You can try reducing the response time or changing the location of the transmitter and/or receiver.
Why does the receiver LED never light up on my SECO-LARM SLI Enforcer E-964-D390Q?
If the Receiver LED on your SECO-LARM Security Sensors never lights up when the beam is interrupted, there are several possible causes: insufficient voltage, the beam being reflected away from the receiver, or the beams not being simultaneously interrupted. Here's what you can do: * Double-check the voltage. * Clean the cover. * Check the overall installation.
What to do if beams are interrupted but no alarm triggers on SECO-LARM SLI Enforcer E-964-D390Q Security Sensors?
If the beams are interrupted and the LED lights up, but there is no alarm trigger on your SECO-LARM Security Sensors, the alarm trigger cable may be cut, or the relay contact stuck due to overloading. Check the continuity of the wiring between the sensor and the alarm.
Why does the alarm trigger become erratic in bad weather for SECO-LARM SLI Enforcer E-964-D390Q?
If the alarm trigger on your SECO-LARM Security Sensors becomes erratic in bad weather, it is likely due to the lenses being out of alignment. Check the overall system installation and realign the lenses if necessary.
How to fix a SECO-LARM Security Sensors transmitter LED that does not light?
If the Transmitter LED on your SECO-LARM Security Sensors does not light, it could be due to being incorrectly wired and/or insufficient voltage. Ensure the power supply to the transmitter is 12 to 24 VAC/VDC.
General| Number of Beams | 4 |
|---|---|
| IP Rating | IP65 |
| Temperature Range | -13°F to 131°F (-25°C to 55°C) |
| Detection Method | Infrared Beam Interruption |
| Range | Up to 390ft (120m) outdoor |
| Tamper Output | Form A relay, 0.5A@24VDC |
| Alignment Angle | ±90° Horizontal, ±10° Vertical |
| Response Time | 50ms to 700ms |
| Housing | Polycarbonate |
| Detection Angle | ±10° |
To Next Page
