Secure radbot 1 - Technical specifications; LED pattern

Technical specifications
Electronic radiator controller
incorporated control, type 1 action
Residential/similar use,
indoor only
L x W x H = 90 mm x 55 mm x 55 mm
Approx 164 grams
2 x 1.5 V (LR6) AA alkaline batteries
3 μW sleep, 1.5 W peak
2 years
0 to 40°C
-20 to 60°C
90°C
15°C to 24°C, Frost protection 6°C
1°C
Linear motion 5.8 mm max
70 N max
IP30
2
Ball pressure test verified at 75°C
Product description
Recommended use
Type code SCV100
Size (including retaining ring)
Weight (including batteries)
Power
Power consumption
Battery life (normal operating conditions)
Temperature range (working)
Temperature range (storage)
Max water circulation temperature
Temperature set point range
Temperature set point interval
Motor
Pin force
Protection class
Pollution degree
Others
When
Power-on When the batteries are inserted One long (~1s) flash to indicate
the device is active
On starting boost mode
Acknowledging adjustment of
the dial
Immediate long flash on releasing
the Boost button, medium flash
every 2s for two minutes and then
flash every 8s for up to about 30
minutes if the room is not dark.
Single flash once the dial position
has been changed
Low battery warning
When a hardware or software
unrecoverable failure is
detected
Continual rapid flashing, more
than once per second, until battery
exhausted or replaced. Radbot 1 will
not operate.
Repeated medium flash every 2s
until battery is exhausted or replaced.
Most Radbot 1 features will not
operate.
Boost
Acknowledge
Low Battery
Fault
Name
Description
LED pattern
15