Secutron MR-2900

68
Appendix D: Table of Reporting Codes
* Call directions: A/R = alarm/restoral; T/R = trouble/restoral; MA/R = maintenance alarm/restoral; S/R =
supervisory/restore; T = test transmission
** Line number/telephone number is identified (XX)
Program any of these codes for zone alarms/restorals when using the standard (i.e. not
automatic) Contact ID reporting format:
Dialer Bus
Trouble/
Rest.
Dialer Bus connection is lost/restored MA/R (3) 33
NT-000/
NR-000
Line 1 or 2 TLM
Trouble/Rest.
connection via Telephone Numbers 1
or 2 is lost/restored
MA/R (3) 51
LT-XXX/
LR-XXX**
Phone # 1 or 2
FTC Trouble/
Rest.
communication is restored after a
failure to communicate trouble has
occurred; events not communicated
during lapse will be sent
MA/R (3) 54
YC-XXX/
YK-XXX**
Walk Test Start/
Stop
control panel has entered/exited walk
test mode; no
events will be communicated
MA/R (6) A7
TS-000/
TE-000
Test
Transmission
Normal/
Off-Normal
test transmission reports system
normal or off-normal (alarm,
supervisory or trouble) control panel
condition
T(6) A2
RP-000/
RY-000
Table 2: Contact ID Zone Alarm/Restore Event Codes
Medical Alarms (1)18 Near Alarm 24 Hour Non Fire
(1)A1 Emergency Panic Alarms (1)51 Gas Detected
(1)A2 Fail to Report In (1)2A Panic (1)52 Refrigeration
Fire Alarms (1)21 Duress (1)53 Loss of Heat
(1)1A Fire Alarm (1)22 Silent (1)54 Water Leakage
(1)11 Smoke (1)23 Audible (1)55 Foil Break
(1)12 Combustion General Alarms (1)56 Day Trouble
(1)13 Water Flow (1)4A General Alarm (1)57 Low Bottled Gas Level
(1)14 Heat (1)4A General Alarm (1)58 High Temp
(1)15 Pull Station (1)43 Expansion module failure (1)59 Low Temp
(1)16 Duct (1)44 Sensor tamper (1)61 Loss of Air Flow
(1)17 Flame (1)45 Module Tamper
Table 1: Automatic Contact ID/SIA Reporting Codes (Continued)
Reporting Code Code sent when... Dialer
Direction*
Contact
ID Auto
Rep.
Codes
SIA Auto
Rep. Codes