8
Face Shield:
Clean the face shield on a regular basis. It is best and easiast to remove bugs
and dirt immediately after use. Remove the shield from the helmet before
cleaning. Use a cleaner designed for use on helmet face shields or use warm
water, non-abrasive hand or dish soap and a clean soft cloth. Use only light
pressure to remove dirt. Blot dry. Do not use paper products or paper towels
to clean or dry the face shield as this will scratch it. Before reinstalling the
face shield inspect the shield base plates. Clean the base plates and snug the
screws as needed.
Interior Comfort Liner:
Cleaning the helmets interior liner with motorcycle helmet cleaner can help re-
duce odor caused by bacteria and mildew as well as keep your helmet feeling
and smelling fresh.
Non-Removable Liner:
Be very careful when cleaning non-removable helmet liners. Improper cleaning
may damage the adhesives that hold the liner in place. It is best to use a cleaner
designed for washing motorcycle helmet liners. Gently hand wash the liner.
Thoroughly rinse any cleaning agent. Blot with a clean cloth or towel to absorb
as much water as possible then air dry.
Removeable Liner:
Remove the liner from the helmet. Use a cleaner designed for washing mo-
torcycle helmet liners or use mild hair shampoo. Gently hand wash the liner.
Thoroughly rinse any cleaning agent. Blot with a clean cloth or towel to absorb
as much water as possible and then air dry. Do not put the liner in the dryer.
Interior Safety EPS Foam:
Use extreme care cleaning this impact absorbing part of the helmet. The EPS
foam can be easily damaged. Press very softly and use only warm water and a
dry cloth. Blot dry with a soft cloth or towel. Never apply heat or solvents.
HELMET CLEANING INSTRUCTIONS
To Next Page
Loading...