Need help?Do you have a question about the Seedburo 801-10/C and is the answer not in the manual?
Connect the cables from OCC (P17 Figure 3-3 #1, SHB CONTROL and P18 Figure 3-3 #2, SHB POWER) to the mating connectors on the rear of the SHB.
The first time the unit is used, or if the unit has been left unpowered for more than 3 months, the operating parameters should be programmed.
An operating mode must now be selected. There are 4 operating modes which may be selected.
Place the seeds to be counted into the bowl. Be sure bag(s) are in position on the chute(s). Press START.
The vibratory feeder may be stopped at any time by pressing the STOP switch (or optional foot-switch).
The Gate Time is adjusted by selecting MENU, setting the Bag Detect Function off, selecting the power line frequency, and then entering a number for the Gate Delay Time.
The power line voltage required to operate the OCC can be changed by adjusting the voltage selector card.
Procedure for checking and replacing springs in the vibratory feeder base.
General| Brand | Seedburo |
|---|---|
| Model | 801-10/C |
| Category | Cash Counter |
| Language | English |
To Next Page
