SeeTech iHunter 2.0 CIS/FIT

Need help?

Do you have a question about the SeeTech iHunter 2.0 CIS/FIT and is the answer not in the manual?

Summary

Chapter 5: Operation

5-1. Self Diagnosis

Procedure for initiating and interpreting the machine's self-diagnostic tests.

5-5. Maintenance

Guidelines for regular upkeep and cleaning of the machine.

5-6. Trouble Shooting

Recommendations for resolving operational issues and errors.

Chapter 7: Disassembly & Assembly

7-1. Main Board Disassembly

Step-by-step guide for removing the main control board.

7-2. Motor Board Disassembly

Procedure for disassembling the motor control board.

7-3. Detector Module Disassembly

Instructions for removing the main detector module assembly.

7-5. CIS Board Disassembly

Guide for removing the CIS (Contact Image Sensor) board.

7-6. CF Board Disassembly

Procedure for disassembling the CF (Counterfeit) detection board.

7-7. CF Rear & MR Sensor Disassembly

Steps for removing the CF rear and MR sensors.

7-8. IR Rear Sensor Disassembly

Instructions for disassembling the IR (Infrared) rear sensor.

7-9. CIS (Contact Image Sensor) Disassembly

Detailed steps for removing the CIS sensor unit.

7-10. Upgrade & External Board Disassembly

Procedure for removing upgrade and external interface boards.

7-11. Display Board Disassembly

Guide for removing the machine's display board.

7-12. SMPS Disassembly

Steps for removing the Switch Mode Power Supply (SMPS).

7-13. Main Motor Disassembly

Procedure for removing the main drive motor.

7-14. Sub Motor Disassembly

Steps for removing the auxiliary drive motors.

7-15. Solenoid Disassembly

Guide for removing the machine's solenoid components.

7-16. Kicker Roller Rubber Disassembly

Procedure for replacing the kicker roller rubber.

7-17. Bite Roller Assembly Disassembly

Steps for removing the bite roller assembly.

7-18. Split Roller Assembly Disassembly

Guide for removing the split roller assembly.

7-19. Reject Sensor Disassembly

Procedure for removing the reject sensor unit.

7-20. Reject Pocket Disassembly

Steps for removing the reject banknote pocket.

7-21. Stacker Sensor Disassembly

Guide for removing the stacker sensor.

7-22. Real Time Board Assembly

Procedure for assembling or disassembling the real-time clock board.

7-23. IR Board & IR Connector Board Disassembly

Steps for removing the IR board and its connector board.

Chapter 8: Upgrade & Calibration

8-1. Upgrade Instruction

8-2-1. Main Board Setting

8-2-2. CF Board Setting

8-2-3. IR Board Setting

8-2-4. CIS Board Setting

8-3-1. Technical Service Menu

8-3-2. Supervisor Menu

8-3-3. CIS Test Mode

8-3-4. CF Level Adjust Mode