Need help?Do you have a question about the SeeTech ST-150 and is the answer not in the manual?
Identifies and labels the external parts of the currency sorter.
Describes the various sensor modules and their locations within the machine.
Details the process for removing and handling the Merlin board and TFT display.
Guides the disassembly and removal of the detection module and Argos board.
Explains how to access and remove the MG sensor modules.
Covers general module disassembly procedures, focusing on removing covers and pulleys.
Provides instructions for disconnecting and removing the motor drive board.
Details the steps for accessing and removing the communication (COMM) board.
Outlines the procedure for disassembling and removing the main motor assembly.
Explains the process for removing the kicker motor, referencing previous sections.
Guides the disassembly and removal of the stacker motor.
Details the steps involved in disassembling and removing the solenoid component.
Covers the process of removing the SMPS (Switch Mode Power Supply) board.
Step-by-step guide for calibrating the CIS (Contact Image Sensor) settings.
Instructions for calibrating the CF (Counterfeit Fitness) level.
Details the calibration process for MG (Magnetic) sensor settings.
Provides guidance on calibrating the UV (Ultraviolet) sensor settings.
Explains the calibration procedure for double currency detection settings.
Instructions for calibrating the tape sensor, specifically for the Fitness model.
Details the calibration process for fitness detection levels.
Guide on how to calibrate the motor speeds for optimal performance.
General| Brand | SeeTech |
|---|---|
| Model | ST-150 |
| Category | Cash Counters & Coin Sorters |
| Language | English |
To Next Page
