SEGA Confidential
8
Supported: 0AH PAN pot
Rewrites the layer parameter
DIPAN of all applicable voice numbers in the tone
bank (
SCSP.BIN) that is set for each MIDI channel.
The normal default fixed position is the pan setting of the original voice data. When
a MIDI program change is issued, the pan control data of the applicable MIDI
channel become invalid.
Supported: 10H Mixer change
Uses MIDI control number 16.
When this control change is issued, the data of the applicable mixer number in
the tone bank (
TONE.BIN) of the applicable MIDI channel are written to the
DSP block (
EFREG0-15, EXTS0, EXTS1) of the SCSP sound generator. Therefore, it is
important to understand the DSP effect status when a mixer change command is
issued. Also, if the specified mixer number is invalid (data does not exist), then it is
ignored.
Mixer # 0 of bank # 0 in map # 0 is set as the default.
Supported: 20H Tone bank change
The start address of the specified tone bank
TONE.BIN is retrieved from the
current Area Map. After this is done, the pitches accessed by the applicable
channel are from this TONE.BIN. Also, since the voice number (program #) of
the corresponding MIDI channel is forced to “0” at the same time, it is necessary
to set the voice number by means of a MIDI program change command before a new
sound is played.
Bank # 0 is set as the default.
Supported: 40H Damper
When the damper is enabled (on), key-off of the applicable channel is no
longer executed. When the damper is disabled (off), all of the slots that were turned
on during the damper-enabled period of the applicable channel are turned off.
To Next Page
Loading...
Need help?
General
