Before storage, please turn off the scooter and fully charge it to avoid over-discharge, which will cause permanent damage.
Charge the scooter every 30–60 days for long-time storage.
Store in a cool and dry place indoors. Exposure to sunlight and temperature extremes (both hot and cold) will accelerate the
aging process of the vehicle components and may permanently damage the battery. If the temperature of the storage
environment is lower than 32°F (0°C), do not charge it until after placing it in a warm environment, preferably over 50°F (10°C)
Do not store in a dusty environment, otherwise the electrical components may be damaged. Do not store where the scooter
may be eroded by chemicals.
WARNING
Prolonged exposure to UV rays, rain and the elements may damage the enclosure materials.
Store indoors when not in use.
Keep way from fire!
Battery
A well-maintained battery can perform well even after many miles of riding. Charge the battery after each ride and avoid draining the
battery. When at 72°F (22°C), the battery performance is at its best and the vehicle can achieve a longer range. Electronics inside
the battery record the charge-discharge condition of the battery; damage caused by over-charging or over-discharge will not be
covered by the Limited Warranty.
WARNING
For information about battery and electrical waste, please contact your household waste disposal service, your local or
regional waste management office, or your point-of-sale.
Do not attempt to replace or disassemble the battery. Do not dismantle or puncture the casing. Keep away from metal objects
to prevent short circuit.
Risk of fire and electric shock. No user serviceable parts.
Do not store or charge the battery at temperatures outside the stated limits (see Specifications).
Never charge in areas forbidden by law.
Battery Charger
Regularly examine the charger for damage to the cord, plug, enclosure and other parts. If any damage is found, stop using
until it is repaired or replaced.
The external cable of the charger (power supply unit) cannot be replaced; if the cord is damaged, the transformer must be
discarded and replaced by a new one.
Cable Tension Adjustment
When the brake is too tight or loose, you can thread in/out the brake cable adjuster.
Tighten the brake
Loosen the brake
To Next Page
Loading...
