Disassembling
Power off the Mecha Kit and the Ninebot S.
1
Refer to the assembly steps and operate in the
reverse order.
2
Pass the attachment straps through the
bottom of the Ninebot S and the strap fixing
holes. Tighten the straps.
6
Drip dry the swelling water bullet (see Appendix 1:
Steps for swelling water bullets) and loaded into the
bullet case.
* Make sure no water is poured into the case.
7
d. Align the slots and buckles on the armrest and
frame.
Slide the armrest forward along the slot until you
hear a click sound. Make sure you lock the armrest
tightly.
* Disassemble the armrest: pinch the lower buckles and
pull the armrest backward.
Lift the bumper to place the frame on the Ninebot S.
The Ninebot S should be placed in the direction
shown (Power button facing the front).
* If you have a Ninebot S Kids, you need to replace
the adapter pad first (refer to Appendix 2:
Replacement of adapter pad).
5
Install the battery: press the cover of the battery
compartment to open it and put the battery in.
Then connect the two plug wires of the battery
and the battery compartment. Close the cover.
4
Installation of the mounting plate:
a. Align the two clips of the mounting plate with the two side steel
tubes and snap them in.
b. Insert the two water bullet bottles with water bullets into the side
of the mounting plate where they are to be tied down.
8
12
13
Power Button
To Next Page
Loading...
Need help?
General