16 17
12 Removing the Battery
WARNING
Removing a battery can be dangerous. You risk personal injury from electric shock. If you are not
comfortable removing the battery yourself, please contact your dealer/distributor or email Segway at
technicalsupport@segway.com.
The standard Ninebot One S1 (with a capacity of 310 Wh) has two batteries, one on either side.
Removing one battery reduces the power, range, and weight of the Ninebot One S1. For your safety,
the speed is limited when only one battery is installed. Please ride carefully.
Battery
Compartment
Battery
Compartment
Power switch
Press down firmly on the edges of
the battery cover to snap it in
place. Start at the top and work to
the bottom. Be careful not to
pinch any wires.
Use a Phillips-head screwdriver
to install the battery cover
screws, then press the rubber
plug into place.
Use a Phillips-head screwdriver to
remove the four battery screws as
shown.
Remove the screws
4
Install the battery cover
5 Install screws and plug6
Use a Phillips-head screwdriver
to remove the two screws. Then,
with a firm tug, use your hand to
lift and remove the battery cover.
Power off the vehicle and
disconnect the charger. Then
remove the rubber plug on the
side of the vehicle.
Unplug the black wire (A) first,
then unplug the yellow wire (B).
Pull the connector firmly. Do not
pull on the wire itself or you may
damage it.
B wire
A wire
Remove the rubber plug
1
Open the battery cover
2
Disconnect the wires
3
To Next Page
Loading...
