WARNING
ONLY use the original charger, otherwise the battery will be damaged and there is a risk of fire. Do not use
or charge your battery if the battery is damaged or see a trace of water. DO NOT charge when the charge
port or cable is wet.
6 Activate the S-Max
There are safety risks when learning to ride the S-Max. You must read the Safety Instructions and
follow the New Rider Tutorial in the App before your first ride.
For your safety, your S-Max is not activated at this time and will beep occasionally after Power ON.
Until activated, the S-Max maintains a very low riding speed and steering sensitivity. Install the App
on your mobile device (with Bluetooth 4.1 or above), connect to the S-Max with Bluetooth, and
follow the App instructions to activate your S-Max and follow the training procedures.
Scan the QR code to download the App.
Segway-Ninebot App
Power ON the S-Max. The Bluetooth icon blinking indicates
the S-Max is waiting for a connection.
Follow the prompts to watch the Riding Safety video,
complete the New Rider Tutorial, and then activate the
S-Max.
Install the App and register or log in.
Click Device > Search Vehicle to connect to your S-Max.
The S-Max will beep when the connection is successful.
The Bluetooth icon will stop blinking and remain
illuminated.
1 2
3 4
5 Charging
Charge port
Lift up the cover. Open the rubber cap. Insert the plug into the socket.
* Charging the wrong way can cause
vehicle damage.
Your S-Max is fully charged when the LED on the charger changes from red (charging) to green (trickle charge).
* The control panel and the App cannot be connected to the S-Max at the same time. If you have connected the App,
disconnect the App from the S-Max first, and then pair the control panel.
1 2 3
11 12
To Next Page
Loading...
