Segway SE-3 Patroller - Page 27

25
Info SE-3 Setup Operate Riding
Tips
Battery Maintain T-shoot Warn Contact
Index Schedule
Reverse
Press and hold the Reverse switch ( ) with your left thumb to engage Reverse
mode (Figure 12). To disengage Reverse mode, release the Reverse switch.
See "Riding: Engaging Reverse Mode" (p. 37).
Lights
The Light switch features three positions (Figure 13):
• = lighting OFF
1 = Front/Rear running lights ON
2 = Condition "1" + emergency lights active
Turn Indicators
Push the Turn Indicator switch to the left ( ) to signal a left-hand turn, push
the switch to the right ( ) to signal a right-hand turn. After the turn is com-
pleted, return the Turn Indicator switch to the center position.
Horn/Siren
To activate the Horn, tap or push the Horn switch ( ). To activate the Siren,
keep the Horn switch pushed for about one second or longer. The Horn will
sound initially, then segue into the Siren.
NOTICE:
Be aware of your surroundings when activating the siren, as some people may
be sensitive to loud sounds and/or bright lights.
HazardIndicators
To activate the Hazard Indicators, pull up on the Hazard switch ( ). Brake
lights and Hazard Indicators are enabled regardless of Light switch position;
however, they are not enabled when Power Key is set to OFF.
Figure 12: Left Handlebar Controls Switchgear
Figure 13: Light Switch
Horn/Siren
Turn Indicators
Reverse
DRIVE/
STANDBY
Hazard Indicators
Lights