SEI Industries BAMBI MAX - Technical Bulletin Manual


SEI Industries Ltd. 7400 Wilson Avenue, Delta, B.C. Canada V4G 1H3
T: 604.946.3131 seisales@sei-ind.com www.sei-ind.com
Page 1 of 2
TechnicalB ulletin
Date:June1,2015
ProductLine:
Bambi
Models:BambiMax
Subject:IVCcableinstallation
Background
OlderBambiMaxmanualsinstructoperatorstofastentheIVC powercabletotheIDShuband
deploymentcableusingzip‐ties.Operatorsareinstructedtoprovidesomeslackduringinstallation. 
Despitethis,SEIhasobservedincidencesofthepowercablebeingpulledfromthestrainreliefonthe
IVC,resulting
inwateringress.Thezip‐tiemaygraduallyworkalongthepowercableovertimeand
eliminateslack.
Recomm endations
SEIrecommendsthatoperatorsavoidfasteningthepowercabletotheIDSorIDSdeploymentcableall
together.Insteadtheoperatorsshouldfastenthecabledirectlytothebucketheadwith4zip‐tiesas
illustratedinFigure1.Operatorsmustensurethatthereisatleast6”ofslackin
theline.Itis
recommendedthatoperatorsquicklycheckthatthereisadequateslackinthelinebeforeflight.
NewbucketswillalreadyhavetheinstallationshowninFigure1.