SEI NYLO - NYLO Table Assembly Steps; Step 1: Connect Side Plates; Step 2: Cross-Connect Side Plates; Step 3: Attach Base to Table Top

Step 1
- Spread clean blanket or towel onto work surface
to prevent scratch damage to parts.
- Locate all parts in cartons. Be sure to check
packing materials carefully. Check against parts
list to insure all necessary parts and hardware
available for assembly.
- Place 1pc “L” connecting strip（B）to one of the
holes on the side plate, then insert the bolt（A）
through the flat washer（C）and the “L” connecting
strip（B）and use wrench（D）to tighten. Also place
1pc “L” connecting strip（B）to the other hole
against the side plate, then insert the bolt（A）
through the flat washer（C）and the “L” connecting
strip（B）to use wrench（D）to tighten.
Step 2
- Let side plate #2 and side plate #3 cross place.
Please refer to left photo.
Step 3
- Place table top on a clean blanket or towel, the
face is down.
- Insert bolt (A) thru the flat washer（C）and “L”
connecting strip (B) on the side plate into screw
hole on the back of table top. Insert 4pcs bolt（A）
into 4 screw holes separately. Also use wrench
（D）to tighten.
CK404500TX
“NYLO” TABLE
Assembly Instructions