This is an instruction manual for a SEIKI S HOME 6KG Front Load Washing Machine, model SC-600AU9FLMK2.
Function Description:
The SEIKI 6KG Front Load Washing Machine is designed for domestic use to wash clothes. It features various wash programs suitable for different fabric types and soil levels, including options for cold, warm, and hot washes. The machine is equipped with a detergent dispenser for synthetic detergent powder, liquid bleach, pre-wash detergent, and fabric softener. It also includes safety features such as child lock and mechanisms to prevent operation if the door is not properly closed or if there are issues with water supply or drainage.
Important Technical Specifications:
- Washing Capacity: 6KG
- Power Supply: 220-240V~50Hz
- Rated Power: 2050W
- Standard Water Pressure: 0.05MPa~1MPa
- Dimensions (W x D x H): 595mm x 400mm x 850mm
- Weight: Net: 55 kg / Gross: 58 kg
- Maximum Load of Dry Clothes: 6kg
- Operating Temperature: 0-40°C (using the appliance under 0°C may damage the inlet valve and draining system)
Usage Features:
- Control Panel: The control panel includes a wash program dial, speed settings, pre-delay function, and start/pause button.
- Wash Program Dial: Allows selection of various wash programs such as Quick 15', Rapid 45', Mix, Jeans, Delicate, Cotton ECO, Spin Only, Rinse&Spin, and Heat Wash 90°C.
- Pre-Delay Function: Users can delay washing for up to 24 hours.
- Child Lock: Activated by pressing and holding the "Pre Delay" button for 3 seconds, preventing accidental changes to settings.
- Detergent Dispenser: Divided into compartments for synthetic detergent powder (left), liquid bleach, pre-wash detergent (right), and fabric softener (middle, with a MAX marking).
- Wash Care Symbols: The manual provides a comprehensive guide to wash care symbols to help users choose appropriate wash programs and care for their garments.
- Loading Instructions: Advises users to empty pockets, knot long strips, zip or button items, put small clothes into a pillow slip, turn easy-pilling and long-pile fabric inside out, and separate clothes with different textures.
- Detergent Recommendation: Recommends using low-foaming or less-foaming detergents suitable for front load washing machines.
- First Use: Before the first loaded wash, it is recommended to perform one wash cycle with no items inside to clean out the tube.
- Drain Hose Connection: Two methods are provided for connecting the drain hose: through a water trough or to a branch drain pipe. The drain hose should not be higher than 120cm above the ground and must not have kinks.
- Water Inlet Hose Connection: Requires new hose sets. The inlet pipe connects to the tap and the inlet valve at the back of the washing machine.
- Levelling: The appliance must be levelled carefully using a spirit level, adjusting the feet and locking nuts to ensure stability and proper operation.
- Installation Area: Requires a minimum spacing of 20mm on the sides and behind the appliance for proper ventilation. Direct sunlight should be avoided.
Maintenance Features:
- General Cleaning: Before maintenance, unplug the appliance and close the tap.
- Cabinet Cleaning: The surface can be cleaned with diluted non-abrasive neutral detergents. Any water overflow should be wiped immediately. Sharp items should not be used for cleaning.
- Door Seal and Glass Cleaning: Wipe the glass and seal after each wash to remove lint and stains, which can cause leaks if built up. Remove any coins, buttons, or other objects from the seal.
- Inlet Filter Cleaning: Involves closing the tap, removing the water supply hose, cleaning the filter, and reconnecting the hose. There are separate instructions for cleaning the filter in the tap and the filter in the washing machine (which involves screwing off the inlet pipe, pulling out the filter with pliers, cleaning it with a brush, and reinstalling).
- Detergent Dispenser Cleaning: Involves pressing down an arrow on the softener cover, lifting the clip, taking out the cover, washing all grooves with water, cleaning inside the recess with an old toothbrush, and then restoring the softener cover and pushing the drawer back into position. Alcohol, solvents, or chemical products should not be used.
- Drain Pump Filter Cleaning: Requires caution due to potentially hot water. The detergent solution should be allowed to cool down. The filter should be cleaned periodically to remove yarns and small foreign matters. The pump cover should never be removed during a wash cycle; wait until the cycle is finished and the appliance is empty. Ensure the cover is tightly secured when replacing.
- Troubleshooting (FAQs and Error Codes): The manual provides a list of common problems, possible causes, and solutions, as well as error codes (E30, E10, E21, E12, EXX) with their corresponding issues and remedies. For other issues, customers are advised to contact customer service at info@ayonz.com.
Need help?
To Next Page
General
