English
20
NECESSARY PROCEDURE AFTER BATTERY CHANGE
● When the battery is replaced, the information stored in the IC does not correspond
with the time and date actually displayed. Before using the watch, therefore, be sure
to reset the hands and date, following the procedure below.
CROWN Turn to set MODE INDICATOR to “CHRONO.”.
* If the stopwatch is counting, first press Button B
to stop measurement and then press Button A to
reset the hands.
➡
CROWN
▼
Pull out.
B
A
CROWN
➡
A
B
OR
▼
▼
➠
7
A
B
AND
Press and hold at the same time
for 2 seconds.
* A beep sounds when the
buttons are released, and the
hands start to show
demonstration movement.
Press to stop the hands.
To Next Page
Loading...
