Seiko 6T63A - Battery Replacement Procedure; Hand Setting After Battery Change

SPECIFICATIONS
3/19
Cal. 6T63A
After installing the battery, pull out the crown to the second click position. And then follow the
instructions below to correct the hand positions and set the time.
NECESSARY PROCEDURE AFTER BATTERY CHANGE
Pull out to the second click position when the small second hand is at
the 60 seconds position. The small second hand stops on the spot.
Crown
Push back in to the normal position in accordance with a time signal.
Crown
Watch starts moving with 2-second interval for 10 seconds. Wait until it moves with
1-second interval.*
* Do not move the crown before it ends.
Button B
Press Button B for longer than 2 seconds.
The STOPWATCH minute hand turns a full circle.
● Standard measurement
Button A
START
→
Button A
STOP
→
Button B
RESET
● A ccumulated elapsed time measurement
Button A
START
→
Button A
STOP
Button A
STOP
→
Button B
RESET
→
Button A
RESTART
…→
Restart and stop of the stopwatch can be repeated by pressing button A.
●
Measurement functions
Accumulated elapsed time measurement and split time measurement are available.