Seiko 7F22 - Page 10

SEIKO
Diver's
watch
for
scuba
diving.
If
used
in
sea
water,
rinse
the
watch
in
fresh
water
and
dry
it
com-
pletely.
Do
not
operate
the
crowns
and
button
(for
Cal.
7F38 and 7F39) in water:
NOTE:
Pressure
in
bar
is
a
test
pressure
and
should
not
be
considered
as
corresponding
to
actual,
diving
depth
since
swimming
move-
ment
tends
to
increase
the
pressure
ata
given
depth.
® SHOCKS
Light activities will not affect.your watch, but be careful not
to drop your watch or hit it against hard surfaces as this may
cause damage. °
=» MAGNETISM
Your watch will be adversely affected by strong magnetism.
Keep it away from close contact with magnetic objects.
=» TEMPERATURES
Your
watch
works
with
stable
accuracy
between
a
temperature
range of 5°C and 35°C (41°F and 95°F).
@ High temperature
Temperature
over
60°C
(140°F)
may
cause
battery
leakage
or shorten the battery life.
® Low temperature
Do
not
leave
your
watch
in
very
low
temperature
below
-10°C (+14°F) for a long time, since the cold may cause a
slight time loss or gain.
However, the above conditions will be corrected when. the
watch returns to normal temperature.
= CHEMICALS
Be careful not to expose the watch to solvents (e.g., alcohol
and gasoline), mercury (i.e. from a broken thermometer),
cosmetic spray, detergents, adhesives or paints. Otherwise, the
case, bracelet, etc. may become discolored, deteriorated or
damaged.
=» PERIODIC CHECK
It is recommended that the watch be checked once every 2
to 3 years. Have your watch checked by an AUTHORIZED
SEIKO DEALER or SERVICE CENTER to ensure that the
case, crowns, button, gasket, and crystal seal remain intact.
=CARE OF CASE AND BRACELET
To prevent possible rust on the case and bracelet caused by
dust and moisture, wipe them with a soft dry cloth.
17