7
6
English
English
SETTING THE TIME
Minute handHour hand
Pull out to second click
when the small second
hand is at the 12 o'clock
position.
Turn to set the hour and
minute hands.
Push back into normal
position in accordance with
a time signal.
CROWN
Small second hand
1. When the stopwatch is or has been measuring, if the crown is pulled out to the
second click, the stopwatch will continue the current measurement.
2. When setting the hour hand, be sure to check that AM/PM is correctly set. The
watch is so designed that the date changes once in 24 hours.
3. When setting the minute hand, first advance it 4 to 5 minutes ahead of the desired
time and then turn it back to the exact minute.
▲
▲
SETTING THE DATE
l
Before setting the date, be sure to set the time.
CROWN
Pull out to first click.
t
Turn clockwise until the desired date
appears.
t
Push back in to normal position.
Date
1. Date setting should always be carried out after the time is correctly set.
2. Manual date adjustment is required on the first day after a month that has less than
31 days: February, April, June, September and November.
3. Do not set the date during any time between 9:00 P.M. and 3:00 A.M. Date setting
during this time period may cause failure of date change on the following day.
To Next Page
Loading...
Need help?
General
