Irregular Heartbeat Indicator
If the monitor detects an irregular heart rhythm two or more
times during the measuring process, the Irregular Heartbeat
Symbol " "appears on screen along with measurement
results. Irregular heartbeat rhythm is defined as rhythm that
is either 25% slower or faster than the average rhythm detected
while measuring systolic blood pressure and diastolic blood
pressure. Consult your physician if the Irregular Heartbeat
Symbol " " frequently appears with your test results.
Unit Operation
21
Unit Operation
17
Testing
1. Power On
"START/STOPā
The LCD screen will appear for one second as unit performs
a quick diagnosis. A long tone indicates device is ready for
testing.
Press button until a beep sounds.
Note: Unit will not function if residual air from previous
testing is present in cuff. The LCD will flash " "
until pressure is stabilized.
mmHg
kPa
No
M
D
Unit Operation
18
2.
Initial pressure is first pumped to 190mmHg. If the current
user's systolic blood pressure is over 190mmHg, the unit
will automatically re-inflate to the proper shelf.
Pressurization
Note: Pressurization will gradually subside and ultimately
stop when cuff is not properly applied to the wrist.
If this occurs, pressing the button to
turn the unit off.
" START/STOP "
mmHg
M
D
Unit Operation
19
3. Testing
After cuff inflation, air will slowly subside as indicated by the
corresponding cuff pressure value. A flashing " " will
appear simultaneously on screen signaling heart beat detection.
Note: Remain relaxed during testing. Avoid speaking or
moving body parts.
mmHg
mmHg
M
D
Unit Operation
20
4. Result Display
Three short beeps sound when testing is complete.
The screen will display measurements for systolic and
diastolic blood pressure. An indicator representing
the current measurement will appear next to the
corresponding WHO Classification.
Note: Refer to Page 29~32 for detail WHO Blood Pressure
Classification Information.
mmHg
M
D
Indicator
Unit Operation
22
5.
User may delete their current test result due to unfavorable
testing conditions or for any other reason. To delete the last
test result, press the "SET" button after result is displayed.
If result is not deleted, It will automatically store by date.
Storing Test Results
Note: Wait 3 minutes or longer prior to re-testing.
Power Off
The " START/STOP " button can be pressed to turn off the unit
in any mode.
The unit can turn off the power itself about 3 minutes no operation
in any mode.
If the number of tests surpasses the allotted 120 memories, the most
recent tests will appear first, thus eliminating the oldest readings.
Safety Precaution: If pressure in cuff becomes too extreme
while testing, press the "START /STOP " button to turn
power off. The cuff pressure will rapidly dissipate once the
unit is off.
To Next Page
Loading...