Maintenance
Test Strip Holder
Remove the Test Strip Holder by pressing in on middle of the Test Strip Holder
and sliding it out from the meter. Wipe it with a damp cloth or a mild detergent
and dry it with a dry, soft cloth. Slide the Test Strip Holder back into the meter
by laying it flat on the meter. Firmly press down on the center of the Test Strip
Holder with your thumb and push it in until it clicks into place.
Note: Do not use organic solvents, such as gasoline or paint thinner.
This will cause damage to the meter.
Meter Sensor Area
Remove the Test Strip Holder as described in the previous section. Wipe
down the Meter Sensor Area with a cotton swab. Do not to scratch the
transparent window covering the sensor.
Note: Do not use bleach or alcohol to clean the Meter Sensor Area.
This will cause damage to the meter.
31
To Next Page
Loading...
