Select Brands Tru - Page 9

9
• Make sure the Steam Wand Sleeve is properly installed by sliding it over the Steam Wand until it ts snugly on the Silicone Tab.
• Press the Power Button once to turn the Espresso Maker on. The machine will beep and the Power Button will light up solid blue; this is to
indicate that the Espresso maker is on.
PRIMING THE ESPRESSO MAKER BEFORE FIRST USE:
• NOTE: The Espresso Maker must be primed before rst use to operate properly.
• Align the handle of the empty Portalter with the unlock marking on the left side of the Group Head. The 3 tabs on the Portalter must align
with the notches in the Group Head.
• Raise the Portalter into the Group Head and rotate it counterclockwise until the handle of the Portalter is aligned with the lock marking.
Ensure the Portalter is securely locked in place.
• Add fresh clean water to the Water Tank. It is important to add enough water to be above the Minimum ll line but not exceed the Maximum
ll line.
• Place a large empty container under the Group Head.
• Press the Power Button to turn the appliance on and start the preheating process. The Power Light will ash blue while warming up and will
then become a solid illuminated blue line when ready.
• When the Espresso Maker is in ready mode, press the Double Shot Button. The Power Light will ash blue while the Espresso Maker is in
use, then will beep three times when nished. Allow hot water to ow through the empty Portalter into the container. When the process is
nished, the Power Light will be a solid illuminated blue line.
• Using the black grip on the Steam Wand, rotate the Steam Wand counterclockwise so that the tip of the Steam Wand is pointed into the
container being used for priming.
• Press the Steam Button. The Power Light will illuminate ash red to indicate the steam function is warming and will then illuminate solid red
to indicate Steam function is ready.
• WARNING: Use caution. Hot steam and hot water generated when operating the Espresso Maker can cause burns.
• Rotate the Steam/Hot Water Dial counterclockwise to the steam position icon. Run steam through the Steam Wand for a minimum of 10
seconds.
• Rotate the Steam/Hot Water Dial clockwise to the O position icon to stop the ow of steam.
• Repeat steps 5 through 9 until the Water Tank is empty.
• NOTE: It may be necessary to empty the container during the priming process, so it does not overow.
• NOTE: Between priming steps the Espresso Maker may need to reheat before starting another cycle. The Power Light will ash while reheating
and turn solid blue when the Espresso Maker is ready.