Select Brands Tru - Hints and Tips

12
milk and in a slightly o-center position. This positioning will help create a whirlpool motion while steaming the milk.
• Activate the steam by turning the steam control dial back to the Steam / Hot Water position.
• Slowly move the pitcher up and down. This will enable small sips of air to be introduced into the milk. Introducing the air should sound like
short “sips”, not large “gurgles.”
• After some aeration, and once the pitcher becomes warm to the touch, submerge the Steam Wand more deeply into the milk and position
it so that the whirlpool motion continues in the milk. This will prevent accidental air introduction late in the steaming process, which would
cause large bubbles and poor texture.
• As the milk steams, the volume will expand.
• The frothed milk is ready when the temperature reaches between 140-150°F.
• CAUTION: Do not allow milk to boil.
• Turn the Steam Control Dial to the O position and lower the steaming pitcher to remove the Steam Wand.
• Swirl the frothed milk in the steaming pitcher to fully incorporate the microfoam. Tap the pitcher on a countertop surface to remove large
bubbles.
• Pour frothed milk into brewed espresso as soon as possible for optimum consistency.
• Use the Silicone Tab to swivel the Steam Wand back over the Drip Tray.
• Press the Steam Button again to turn o. The Power Button will switch back from a red light to a solid blue light.
• CAUTION: Steam Wand and Steam Wand Sleeve will be hot.
• Use a towel to remove the Steam Wand Sleeve and rinse it o with running water.
• Wipe the Steam Wand with a moistened towel and purge a small amount of steam to clean.
Dispensing hot water:
• Note: The hot water function can be used to dispense hot water for americanos, teas and more.
• Place a cup under the Steam Wand and activate the hot water function by turning the Steam Control Dial to the Steam / Hot Water position
without activating the Steam Button on the front of the Espresso Maker.
• Once the desired amount of hot water has been dispensed, stop the hot water by turning the Steam Control Dial to the O position.
• Remove the cup and use the Silicone Tab to position the Steam Wand back over the drip tray.
HINTS AND TIPS
• It is recommended to avoid placing the appliance under cabinets, as rising steam can cause damage to wooden furniture.
• Empty the drip tray regularly to prevent it from overowing.
• Preheat coee mugs or espresso glasses on the Cup Warmer to insure proper espresso avoring. NOTE: Do not place anything other than cups
on the Cup Warmer.