TEC Series v 3.2X
Page 34
SYSTEM PARAMETERS
The System Parameters menu comes with factory defaults
that should be sufficient for most installations. These default
values are shown on Pg. 28 and 29 Some functions work with
options that may not be present on your TEC. For example,
selection 2 Alarm Time is not valid unless the optional alarm
control relay (OPTK3R) has been purchased. To get the menu at
left, press "3" from the main menu.
ALARM TIME
Alarm time is the time in seconds that the optional alarm
relay control (OPTK3R) is energized. To change the alarm time
from the factory default of 10 seconds, press "2" from the System
Parameters menu to get this sub-menu. Key in the desired
number (must be 2 digits) and press "*". This will return you to the
System Parameters menu.
ALARM TIME = 10
SYS PARAM.
SELECT 1 - 9
CODE LENGTH
Code length is the number of digits from 1 to 6 entered on
the keypad to dial a phone from the TEC. To change the code
length from the factory default of 3 digits, press "3" from the
System Parameters menu to get this sub-menu. Key in the
desired number from 1 - 6 and press "*". This will return you to the
System Parameters menu.
CODE LENGTH = 3
TALK TIME
Talk Time is the time in minutes from 1 - 99 minutes that
the TEC remains connected after dial out. In areas of the country
where rate usage is a concern, the factory default is 1 minute. For
other applications, the talk time can be adjusted upward by
pressing "1" from the System Parameters menu to get this sub-
menu. Key in the desired number (must be 2 digits) and press "*".
This will return you to the System Parameters menu.
TALK TIME = 01
PIN LENGTH
PIN length is the number of digits from 0 to 6, entered from
the keypad to enter a PIN code from the TEC. To change the PIN
length from the factory default of 4 digits, press "4" from the
System Parameters menu to get this sub-menu. Key in the
desired number from 0 - 6.
SELECTING PIN LENGTH = "0" DISABLES THE PIN FUNCTION.
Press "*" to return to the System Parameters menu.
PIN LENGTH = 4
BACK BEEP
Back Beep is a background tone that will "beep" every 10
seconds when enabled. This allows a called party to determine if
someone called from a TEC. To enable the back beep from the
factory default of 0, press "5" from the System Parameters menu
to get this sub-menu. Press "1" to enable Back Beep, and press
"*". This will return you to the System Parameters menu.
BACK BEEP = 0
To Next Page
Loading...