TEC Series v 3.2X
Page 35
The Title Page has two lines of up to
sixteen characters per line, including punctuation. The Title Page
can be programmed from the keypad in the same manner as
names were programmed. See the table on the next page for
character assignments. The TEC comes with a title page that says "PRESS # TO VIEW
DIRECTORY", until the title page is reprogrammed. To program the Title Page from the factory
default of "PRESS # TO VIEW DIRECTORY", press "9" from the System Parameters menu to get
this sub-menu. Key in the desired character and press "#" to advance to the next character
space. Press "#" to advance to a blank space. Press "#" and "0" simultaneously to backspace
one character. When the first line is complete, press "*" to advance to the second line.
NOTE: IF 0 IS SELECTED, THE TEC WILL PERMIT UNLIMITED ATTEMPTS TO GUESS PIN CODES.
Tone dial selects whether the TEC dials
out with Touch-Tones™, or uses pulses, like rotary dial phones. In
areas of the country where Touch-Tone™ is not available, tone dial
may be disabled. To disable the Tone Dial from the factory default of 1, press "6" from the System
Parameters menu to get this sub-menu. Press "0" to disable Tone Dial, and press "*". This will return
you to the System Parameters menu.
STRIKE OUT
Strike Out refers to the number of incorrect PIN code entries
that can be made before the TEC "locks up". Once the TEC "locks
up", it ignores any key entries for 60 seconds. This is to
discourage attempts to guess PIN codes. Select Strike Out from
the Door Control menu by pressing "9". To change from the factory default setting of 3, press any key
from 0 - 9 and then press "*".
STRIKE OUT = 3
TONE DIAL = 1
OPEN
Unit ID or Ring Count
Unit ID or Ring Count is the number of rings the TEC
listens to before it answers. This is useful for the software
(Selcom 7 or Newer) to identify that it is connected to the correct
unit or for Remote Programming.and If ring count is 0, the TEC
will not answer at all. To change the ring count from the factory default of 3 rings, press "7" from the
System Parameters menu to get this sub-menu. Key in the desired number from 0 - 9 and press "*".
This will return you to the System Parameters menu.
RING COUNT = 3
TITLE PAGE
BUSY PLEASE WAIT
If you enter an invalid PIN code, an error message like
the one at right, will display. Wait until the title screen (if
selected) appears, or until the error message goes away before
re-keying the PIN code.
If the number of strike outs is exceeded, an error tone will
sound. A message like the one at left, will be shown on the front
display of the TEC.
If you enter a valid PIN code, the door control relay will energize
and the open message shown at left, will display on the TEC for
approximately 2 seconds and then revert back to the title page.
INVALID PIN
TRY AGAIN
TONE DIAL
LINE 1
To Next Page
Loading...