TEC Series v 3.2X
Page 43
You will be prompted to select a time zone from 0 - 7 as shown at
right. Select the desired zone number and press the “*” key from
the front door key pad, or the Enter key from a terminal.
Access Levels are used to attach Time Zones to specific Entrances. Only
one Time Zone is allowed per Access Level. Any combination of entrances may be selected, but at
least one entrance must be selected, or the affected Access Level will not function. From one to four
entrances may be assigned to an Access Level. Different combinations of control may be created.
Do this by assigning one entrance a Time Zone and an Access level, and another entrance the
same Time Zone but a different Access Level. Now these Access Levels can be grouped in different
combinations for the Access Groups.
SELECTING AN ACCESS LEVEL
After selecting a group, you will be prompted for levels. These
are any combinations from 0 - 7 in any order. To change access
levels for a given group, key in the new levels desired and press
the “*” key from the front door key pad, or the Enter key from a terminal. To delete access levels
entirely use Clear Access Levels.
LEVELS - - - - - - -
SELECTING AN ACCESS GROUP
Select "6" from the main menu. Press the “*” key from the
front door key pad, or the Enter key from a terminal. Select "1"
from this sub-menu. You will be prompted to select a group
from 1 - 7 as shown at right. Press the “*” key from the front door key pad, or the Enter key from a
terminal.
ACCESS LEVELS
Select "6" from the main menu. Press the “*” key from the front
door key pad, or the Enter key from a terminal.
Select "2" from this sub-menu. You will be prompted to select a level from 0 - 9 as shown at right.
Press the “*” key from the front door key pad, or the Enter key from a terminal.
LEVEL <0 - 7>
GROUP 1 - 7
SELECTING A ENTRANCE
You will be prompted to select a door 1 - 4 as shown at right.
Select the desired door combination and press the “*” key from
the front door key pad, or the Enter key from a terminal.
TIME ZONE <0 - 7>
PROGRAMMING AN ACCESS LEVEL
SELECTING A TIME ZONE
ENT. <1 - 4 >
- - - -
SETUP AND PROGRAMMING
From the main menu select "6" for Access Control.
ACCESS CONTROL
To Next Page
Loading...