TEC Series v 3.2X
Page 47
continued
ZONE STIME ETIME SMTWTFSH
4 00:00 00:00 ---------------
5 00:00 00:00 ---------------
6 00:00 00:00 ---------------
7 00:00 00:00 ---------------
Pressing "2" will send time zones
to a CRT or printer.
ZONE STIME ETIME SMTWTFSH
0 00:00 23:59 1234567---
1 07:45 08:30 -23456-----
2 16:30 17:15 -23456-----
3 00:00 00:00 ---------------
Pressing the menu election “9” is used
with an optional printer (OPTPRT), or a CRT or terminal for sub-
menu choices 1 through 5. Data is sent to the optional serial port.
It is used to print various parameters, such as Time Zones,
Holidays, Access Levels, Access Groups and general Information.
Sub-menu choices 6 through 9 send data to the LCD display on
the front panel of the Tec. To select this function, press "9" from
the Main Menu. You will see the display, shown to the right.
PRINT TIME ZONES
DISPLAY DATA
Pressing any selection from "1" to "5" will cause the display at
right, to be shown briefly.
DISPLAY DATA
SELECT 1 - 5
PRINT INFO
CLEAR ACCESS GROUPS
Pressing "5" causes this selection to clear all access groups of any previously programmed data.
Press “1” to Clear, “0” to Abort. Press “*” to return to the Main menu.
PRINTING BUSY
PLEASE WAIT
CLEAR ACCESS LEVELS
Pressing "4" causes this selection to clear all access levels of any previously programmed data.
Press “1” to Clear, “0” to Abort. Press “*” to return to the Main menu.
CLEAR ENTRANCES
Pressing "6" causes this selection to clear all entrance data. Press “1” to Clear, “0” to Abort. Press “*”
to return to the Main menu.
DISPLAY DATA
SELECT 1 - 5
Next, this message will be shown. Press “*” to return to the sub-
menu and print out other information
Pressing "1" will send the system configuration information (like the example below) for this TEC to a
CRT or printer. VER 3.XX
CODE CAP = 0110
PHONE CAP = 0100
CODE LENGTH = 3
PIN LENGTH = 4
CR BIT TYPE = 1
ENA ACC GRP = 0 (TECs with optional clock, only.)
PRESS # TO VIEW
DIRECTORY
PROGRAM PSWD = 777777
SETUP AND PROGRAMMING
CLEAN DIRECTORY CODES
Pressing "7" causes this selection to clean the corrupted directory codes. Press “1” to Clear, “0” to
Abort. Press “*” to return to the Main menu.
To Next Page
Loading...