Select Engineered Systems TEC Series

To Next Page

To Previous Page

TEC Series v 3.2X

Page 46

TRANSACTION BUFFER INFORMATION continued

This allows the log to be viewed from a terminal connected to the

optional serial port. The log also may be viewed from a personal

computer communicating through the optional modem. Pressing

"1" from the front panel keypad will only show a cursor box in the

LCD display as shown at left. The TEC will sound a long error beep and return to the Buffer

Information menu.



SEND LOG

Press "4" to get to the menu at left. Pressing a "1" then “*”

clears all transactions stored in the buffer for the TEC. If you

press a "1" by mistake, press "#" and "0" simultaneously to

backspace over the "1". Press "0" then “*” to return to the main

menu. If you press any key other than "1", the TEC will sound a

long error beep. Press “*” to return to the Buffer Information

menu. Press “*” again, to return to the Main menu.

ERASE LOG

CONTINUE? 1/0

CLEAR DATA

TRANSACTION BUFFER FREE

Pressing "2" will send all logging data to either the

optional serial port or to the optional modem, if you are using a

terminal through the modem.. A message like the one at left will

display.

VIEW LOG

PRINTING BUSY

PLEASE WAIT

After all data stored in the buffer has been sent, the

message shown at left will display. Press “*” to return to the

Buffer Information menu. Press “*” again, to return to the Main

menu.

BUFFER INFO

SELECT 1 - 4

Pressing "3" from the front panel keypad will only show

the approximate amount of space remaining in the buffer A

message similar to left will appear

BUFF FREE = 70%

SEND LOG

SET PARAMETERS

Pressing "1" returns all Entrance Control, System

Parameters and Communication Setup settings to the SES

factory defaults. These defaults are shown on Pg. 28 and 29.

Press "1" to reset the parameters

Pressing "2" causes this selection to clear any previously programmed time zone and resets all

times to 00:00. Press “1” to Clear, “0” to Abort. Press “*” to return to the Main menu.

CLEAR HOLIDAYS

Pressing "3" causes this selection to clear all Holidays from memory. This is useful for Holidays

that are observed on different days from year to year, such as Thanksgiving or Labor Day. Press “1” to

Clear, “0” to Abort. Press “*” to return to the Main menu.

CLEAR TIME ZONES

SETUP AND PROGRAMMING

Select Engineered Systems TEC Series - Page 52