TEC Series v 3.2X
Page 51
PROGRAMMING CHOICES
MANAGER PASSCODE
The first 3 digits of the 6 digit pass code are for programming main menu choice 1 (CODES/
NAMES) only. This is useful for on site maintenance of names and codes. This prevents the
system parameters and configuration from being inadvertently modified after installation.
Following is an overview of the menu selections possible on a TEC.
MAIN MENU
1 = CODES / NAMES
1 = ADD / FIND NAME FOLLOW MENU
2 = FIND NAME 1 -6 ALPHA NUMERIC
3 = FIND PIN 1—6 DIGITS
4 = FIND CARD 5 DIGITS
5 = CODES USED DISPLAYS # USED
6 = SHOW ALL CODES CRT ONLY
7 = SHOW ALL NAMES CRT ONLY
8 = ENA ACC GRP = 1 ENABLES ACCESS GROUPS
2 = ENT. CONTROL FACTORY
DEFAULTS
SELECT ENT 1 - 4 SELECT ENTRANCE
ENT X
1 = UNLOCK TIME 1 -99 SECONDS 10
2 = UNLOCK TONE 0 -9 T-TONE RECV’D 6
3 = AUTO GROUP 0 -7 0
4 = LATCH TONE 0 - 9 T-TONE RECV’D 0
5 = AJAR TIME 0—99 SECONDS 0
3 = SYS. PARAMETERS
1 = TALK TIME 1 -99 MINUTES 01
2 = ALARM TIME 1 -99 SECONDS 10
3 = CODE LENGTH 1 -6 DIR LENGTH 3
4 = PIN LENGTH 0 -6 PIN LENGTH 4
5 = BACK BEEP 0-1, (1 = ENABLE) 0
6 = TONE DIAL 0-1, (1 = T-TONE DIAL) 1
7 = UNIT ID 0 -9 RING COUNT 3
8 = STRIKE OUT 0-1, (1 = ENABLE) 0
9 = TITLE PAGE
To Next Page
Loading...