SelectBlinds ERB25 User Manual

Operation
Item
Item Operation Result Illustration
1
Keep pressing the
SETTING button battery
pack for more than 3
seconds
Rlease this button when
motor jogs
2
Press the CONFIRM
button on transmitter
Motor jogs, the program
has been done.
1
Press UP button
If motor goes up, please do
nothing, If motor goes down,
please do next step
2
Press and hold LIMIT button
then press STOP button
Release both buttons when
motor jogs
3
Press UP button
Motor goes up, the motor
rotation direction has been
revised
1
Keep pressing LIMIT
button on any
programmed transmitter
Rleasethis button when
motor jogs
2
Press DOWN button on
transmitter
Motor runs down
3
Press STOP
button When
motor running close to the
end-point of bottom limit
Motor stops
4
Press either UP or
DOWN
button
Motor runs step by step to
adjust bottom limit
accurately
5
Press CONFIRM button
on transmitter
Motor jogs, down way
setting has been done.
The whole limit setting must be finished at one times
● Please skip the step and go to next If manufacturer has programmed a transmitter with motor
before delivery
ERB25 Rechargeable Battery Motor Instruction
Technical data
Motor Load Torque: 0.7Nm/34rpm 1.1Nm/28rpm
Battery Specification: Li-ion Batter, 2000mAH, 7.4V.
Notify:
●The side of motor head with SETTING button
should face to you ( toward outside)
●
Motor antenna should be as straight as
possible in the position far away from metal objects. Directly contact
metal objects is prohibited; otherwise, the receivindistance will be influenced seriously.
●Please charge the battery when the motor alarm or work faltering
Setup
bottom limit
Program the
first
transmitter
with motor
Change
motor rotate
direction

SelectBlinds ERB25 Specifications

General

Brand	SelectBlinds
Model	ERB25
Category	Engine
Language	English

Summary

Motor Programming and Configuration

Program First Transmitter

Steps to pair the initial transmitter with the motor using SETTING and CONFIRM buttons.

Change Motor Rotation Direction

Instructions to reverse the motor's UP and DOWN direction using LIMIT and STOP buttons.

Setup Bottom Limit

Procedure to set the motor's lowest operational position using specific button presses.

Setup Upper Limit

Procedure to set the motor's highest operational position using specific button presses.

Program Additional Transmitter

Steps to program a new transmitter to an already configured motor.

Advanced Motor Operations

Set Intermediate Position

Steps to define a custom intermediate stopping point for the motor's operation.

Delete All Other Transmitters

Method to remove all previously paired transmitters from the motor.

Delete Transmitter Itself

Procedure to unpair the current transmitter from the motor.

Maintenance and Troubleshooting

Charging the Motor Battery

Information on charging the motor's Li-ion battery using the specified charger.

Frequently Asked Questions

Common questions and troubleshooting advice for motor operation issues.