8
Hold
In the parameter settings you can choose one of these 5 hold options
1. Peak Hold: Grabs the highest weight (for materials testing, ie. tension and pulling
force)
● Press the HOLD key then add weight to the scale
● The indicator will show the highest weight it recorded and hold it on the screen until
a higher weight is placed on the scale
2. Manual Hold: Grabs the current weight and holds it so it will not change/uctuate
● While weighing, press HOLD and the indicator will hold the current weight on the
screen until HOLD is pressed again
3. Auto Hold: If the weight on the scale is above 20d and is stable, the indicator will
hold that weight on the screen for 3 seconds then go back to general weighing
● Pressing the hold key is unnecessary, holding is done automatically when the scale
is stable
4. Average Hold: Used for animal weighing, the indicator will display the average
weight sampled from 3 or 5 seconds (Set in the C12 Parameter)
● Add animal to scale and press HOLD
● Indicator screen will show “
LOC
” for 3 or 5 seconds, then display the average
weight from those 3 seconds
● Press HOLD again to exit holding mode
5. Auto Average Hold: Used for animal weighing, the indicator will display the aver-
age weight sampled from 3 or 5 seconds without the need to press the HOLD key.
If the weight on the scale is above 20d and is stable, the indicator will start grabbing
the average weight sampled from 3 seconds.
● Begin loading animal to scale, after 5 seconds the Indicator screen will show “
LOC
”
for 3 seconds
● It will then display the average weight from those 3 seconds for 3 seconds and then
repeat the process
Print
● If the indicator is connected to a printer and the communication mode is set to print
mode (C18 =2) and the weight on the scale is stable press and hold the SET key to
print the current weight
Print out example:
Net weight
Tare weight
Gross weight
Print out number
N.W.: 25.6lb
T.W.: 10.3lb
G.W.: 35.9lb
NO. 01
To Next Page
Loading...
Need help?
General
