Sencor 3cam 4k02w - Charging and Powering On;Off

To Next Page

To Previous Page

EN 7

Start-up

Tip: anew battery reaches full capacity after about 3 charging cycles. We recommend

fully charging the battery (until the red indicator goes off) and deplete it until the camera

switches off. This extends the battery life.

Note: the camera can be operated even without abattery with an external power supply,

for example in the car. Unexpected states can occur with alow battery inserted, including

spontaneous shutdown. Charge the camera battery at least alittle when using the camera

for the ﬁ rst time.

3.3. Charging

The inserted battery can be charged either by connecting the camera to acomputer or

using apower adapter. The adapter must supply an output voltage of 5 Vand can either be

anetwork adapter or car adapter. Prior to connecting the power adapter, make sure its voltage

is compatible with the network voltage, or voltage supplied by the vehicle.

The camera can be charged in both on and off states. Recordings can be made during the

charging process (e.g. in the car). The charging indicator is on while charging (top, left). The

adapter, battery and camera become slightly warm while charging. This is anormal effect of

energy conversion.

3.4. Switching the camera on and off

1. Press and hold the switch for 3 to 5 seconds to switch the camera on or off. Ablue

indicator (bottom, left), or active display (based on the current settings: PowerSave)

indicate the camera is on.

AM 4K01W SENCOR EN CZ SK PL HU.indb 7 8.6.2016 14:25:0