Sencor ONE 2020 - Multifunctional button; Assembly of the scooter Scooter One 2020

6 EN
EN
Revision 10/2021Copyright © 2021, Fast ČR, a. s.
Assembly of the scooter Scooter One 2020
WARNING:
Always start the operating mode when the SENCOR SCOOTER ONE 2020 is not
in motion.
2.4. Multifunctional button
WARNING:
Always adjust the driving functions before starting the ride.
1) When switched off, press the multifunction button briefly to turn Scooter One 2020
on.
2) When on, pressing and holding the multifunction button for 2 seconds turns Scooter
One 2020 off.
3) When switched on, briefly pressing the multifunction button switches the LED lamp
on.
4) When switched on, a short double-press of the multi-function button switches
between driving modes.
3. Assembly of the scooter Scooter One 2020
1. Straighten the handlebar bar and clamp it firmly using the locking lever.
2. Check the connections of the control unit connectors to the Control panel. The
connector with wires must be properly connected to prevent any loosening later.