Sencor SBD 1470 - Page 11

Digital Blood Pressure Monitor with a Wrist Cuff
SBD 1470
STORAGE
. If you will not Бе using the device for an extended period of time, remove the batteries.
° Protect the device against impacts and falls.
. Store the device in а clean, dry place out of reach of children. Do not expose the device to direct
sunlight or extreme temperature changes.
CALIBRATION
Recommendation: To ensure accurate measurement results we recommend the device is calibrated after
two years of operation. All costs associated with the calibration are borne by the customer.
ELECTROMAGNETIC INTERFERENCE
To prevent measurement inaccuracies caused by electromagnetic interference, do not use this device in
the vicinity of mobile telephones or microwave ovens.
COMPLIANCE WITH STANDARDS
This device complies with European standards:
EN 60601-1 Medical electrical devices - Part 1: General basic safety and necessary functionality
requirements
EN 60601-1-2 Medical electrical devices - Part 1-2: General basic safety and necessary functionality
requirements - Group norm: Electromagnetic compatibility - Requirements and tests
EN 1060-1 Non-invasive blood pressure monitors - Part 1: General requirements
EN 1060-3 Non-invasive blood pressure monitors — Part 3: Specific requirements for electromechanical
systems for the measurement of blood pressure
С Є: This device meets the requirements of the European directive 93/42/EEC.
al The manufacturing date is marked on the rating label of the device.
wd Manufacturer: Zhongshan Transtek Electronics Co., Ltd
Jinan Road, Jinbiao, Minzhong, Zhongshan, Guandong, China
Authorised representative for the EU: MDSS - Medical Device Safety Service GmbH,
| Ec (ке Schiffgraben 41, 30175 Hannover, Germany
EN-11
Copyright © 2012, Fast ČR, a.s. Revision 11/2012