Sencor SHB 4356 - Page 2

Hand Blender
SHB 4356
Important safety instructions
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabili-
ties, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they will not play with the appliance.
- Before connecting the power cord to the wall outlet, make sure that the voltage is compatible with the voltage shown
on the label on the blender. Se)
- Never use the blender close to water, bathroom, swimming pool or showering room. (cL
- Never use accessories that are not originally supplied with your product or accessories that are not designed to be used
with your product.
- Do not place the blender on window ledge.
e Make sure that the power cord or the power cord plug are not in contact with water or are wet before connecting it to
the wall outlet.
- Place the blender on even and flat surface.
- Do not pour water or any other liquids into the appliance.
- Always disconnect the appliance from the supply if it is left unattended and before assembling, disassembling or cleaning.
- Your blender has been designed for household use only. It is able to handle regular amounts of food.
e Do not use the blender for commercial purposes or outdoors!
- Do not use any spray bottles around the blender.
e Do not allow children to use the blender without supervision.
- If you are not using the blender, always disconnect the power cord form the wall outlet. Store away from children.
- Do not place the blender on hot surfaces such as electric or gas oven. Also do not place it close to heat producing equi-
pment or close to an open fire.
- Do not use damaged blender or if it is not working properly. Do not use if the power cord or the power cord plug are
damaged.
- If you discover damaged power cord or power cord plug, have it repaired by authorized service centre only.
e Never attempt to repair the appliance yourself. There is a risk of electrical shock. Have all repairs and adjustments done
by an authorized service centre or repair shop. Any attempt to perform repair or adjustment during the warranty period
will void the warranty.
- Do not place the power cord close to or on hot surfaces. Do not place on sharp objects. Do not place heavy objects on
the power cord. Place the power cord in such way, so no one will step on it or trip over it. Make sure that the power cord
is not hanging down from a table. Make sure it is not touching hot surfaces.
e When disconnecting the power cord from the wall outlet, do not pull it by the cord. You may damage the cable or the
wall outlet. Instead, hold the power cord plug and pull it out of the wall outlet.
e Use the blender only for purposes for which it has been designed.
e Make sure that the appliance is switched off and unplugged before attaching the removable part to the motor unit or
its removing.
- Do not switch on the appliance unless the removable part is properly attached to the motor unit. Do not switch on the
appliance idly. Improper use could adversely affect the life of the appliance.
- Do not place your hands inside the mixing container while the device is operating.
- Do not place inside the mixing container items that you do not wish to be mixed.
e Use extreme caution when blending hot foods or hot items. Use only small portions. Hot mix may spill out and cause
severe burns. If the items to be blended are very hot, allow them to cool down to a temperature at least 60 °C.
e Never use the blender for mixing or blending foods that are being cooked on an electric or gas stove.
- The operation time is 1 min. After one minute of use, let it rest for at least two minutes. If you are using the blender for
mixing heavy or hard food items, we recommend taking a break every 20 — 30 seconds.
e Caution! The cutting knifes are very sharp. Never attempt to touch the spinning knifes.
How to use your blender
Remove all packaging materials. Attach the lower removable part to the motor unit.
During the assembly observe the symbols fr] - showing the direction for locking and ah showing the direction for
releasing. Symbols are located on the rear side of the blender.
Before first use, please clean the mixing container with hot water and mild detergent. When finished rinse thoroughly
under running water.
EN-2
Copyright © 2011, Fast CR, a.s. Revision 06/2012