Hair Clipper
SHP 320SL
EN
EN-7
2019 07/2019
OPERATING THE HAIR CLIPPER
• Before first use take the hair clipper and its accessories out of the packaging material.
PREPARATION BEFORE THE HAIRCUT
• Seat the person whose hair you will be cutting in such a way that their head is at the height of your
chest. This will provide for a comfortable cutting position.
• Cover the neck and shoulders of the person whose hair you will be cutting with a towel to limit cut
hair from falling on their clothes.
• Only use the hair clipper on clean dry or dampened hair. Before the cutting hair, thoroughly comb
out the hair in the growth direction.
USING THE HAIR CLIPPER WITH THE COMB ATTACHMENT
• The hair clipper is supplied with 4 comb attachments B1–4 for cutting lengths of 3, 6, 9 and
12 mm. Select one of the attachments B1–4 and attach it to the cutting unit A1 according to the
instructions below.
• Place the comb of the attachment C1 on to the blade of the cutting unit A1 and push the heel
of the attachment C2 against the bottom part of the cutting unit A1. When the heel of the
attachment C2 is pushed against the cutting unit A1 an audible click will be heard. Check that
the comb attachment is securely fitted to the cutting unit A1.
C
1
2
1 Comb of the attachment
2 Heel of the attachment
Note:
Information about the cutting height is shown on each of the attachments.
USING THE HAIR CLIPPER WITHOUT THE COMB ATTACHMENT
• Use the lever A2 to regulate the cutting height without the use of the comb attachment B1–4.
• If you want the cutting height to be as short as possible, press lever A2 with your thumb upwards
as far as it will go. Hair will be cut directly above the scalp. This setting is suitable for trimming hair
on the neck and around the ears.
• Push the lever downwards as far as it will go to set a cutting height of approximately 3 mm.
• Insert the power plug A6 into the an electrical power socket. To start the hair clipper, move switch
A4 to the ON position.
To Next Page
Loading...