Sencor SHP 320SL - Replacing the Cutting Unit; Technical Specifications; Glossary of Technical Terms

Hair Clipper
SHP 320SL
EN
EN-9
2019 07/2019
REPLACING THE CUTTING UNIT
• If the cutting unit A1 is worn out, please contact an authorised service centre.
• If you replace the cutting unit A1 yourself, use only original spare parts and proceed according to
the following instructions.
• Use a cross-head screwdriver to loosen the screws on the underside of the cutting unit A1. Take off
the bottom and top part of the cutting unit A1. Attach a new top and bottom part of the cutting
unit A1 to the body of the hair clipper A3. Ensure that both parts are seated correctly. The blade
must be parallel. If the lever A2 is in the top position, the top edge of the upper blade should be
level about 1.2 mm under the upper edge of the bottom blade. Use screws to attach the cutting unit
A1 to the body of the hair clipper A3. If you find that the top and bottom parts of the cutting unit
A1 are not properly level, slightly loosen the screws. Adjust the blade level and retighten the screws.
TECHNICAL SPECIFICATIONS
Nominal voltage ..............................................................................................................................220–240 V
Nominal frequency .............................................................................................................................50/60 Hz
Rated power input .....................................................................................................................................7 W
Safety class (for electric shock protection) ................................................................................................... II
Noise level ..........................................................................................................................................63 dB(A)
The declared noise emission level of the appliance is 63 dB(A), which represents a level A of acoustic
power with respect to a reference acoustic power of 1 pW.
Glossary of technical terms
Safety class for electric shock protection:
Class II – Electric shock protection is provided by double or heavy-duty insulation.
Changes to text and technical parameters are reserved.