Sencor SLE 1955M4 - Page 24

NE] Basic controls
6. The channel scan will commence. The scanning process may take some time. The
display will show the progress of the tuning and the number of channels found.
7 df you want to skip the ATV scan, press the MENU button to interrupt the scan half
way through. A dialogue box will appear on the screen, with the « button, select
Yes (Yes) to confirm. Then you will go directly to the DTV scan. You mau repeat
he above described step if you also wish to skip the DTV scan. After turning on
he television again, a message about the installation of the television will be
shown.
8. After the scan is complete, the channels are arranged in a preset order. If you wish
o skip certain channels, modify the channel order or rename channels, select
Programme Edit (Edit program) in the Channel menu .
Channel Tuning
Notes:
If the scanning type is DTV+ATV, it is possible to scan for all channel types ATV, DTV
and radio at the same time.
All stored channels will be removed after an automatic scan.
After the automatic scan the screen will switch to the first DTV channel.
5.3.3. DTV Manual Tuning (Manual DTV search) ( DVB-T)
1. Use the MENU button and then use the </> buttons to select the CHANNEL
(CHANNEL) item and then enter the menu by pressing the OK button.
2. Use the A/F buttons to select DTV Manual Tuning (Manual DTV search) and then
press the OK button.
A
Auto Tuning
DTV Manual Tuning
ATV Manual Tuning
$ Programme Edit
< CHANNEL N d Signal Information -
' Cl Information
Software Update(USB)
v
$% 2008 &
22 EN
Copyright © 2014, Fast CR, a. s. Revision 04/2014