4 EN
EN
Revision 09/2016Copyright © 2016, Fast ČR, a. s.
Important safety conditions
• Avoid carrying the device from acool environment into awarm environment or vice
versa, or operating the device in amoist environment. Air moisture may condense in
some areas within the device case and may cause the device to become temporarily
inoperable. In this case, leave the device in awarm and well-ventilated area and
leave for 1–2 hours until the moisture evaporates. The device can be normally used
again. Be especially cautious when using the device for the first time during acool
season immediately after purchasing.
• Do not place the device on an unstable cart, stand, console or table. The device can
fall and cause serious injury to children or adults or seriously damage the device
and other objects. Only carts, stands or tables defined by the manufacturer or sold
with the device shall be used. Any mounting of the product should be carried out
according to manufacturer's instructions and should use amounting accessory
recommended by the manufacturer.
• Do not lean against the device, do not lean over or use the device as astep. Avoid
quick movements. Make sure children do not play with the machine.
• Be careful when moving the device when placed on acart. Suddenly
stopping, using excessive force and uneven surfaces may cause the cart
holding the device to tip over.
• Under no circumstances are the manufacturer or vendor liable for any
direct or indirect damage caused by the failure to observe the instructions for
installation, configuration, operation, treatment and cleaning of this device included
within this manual.
• Protect the device against impacts, falls, blows, shocks, vibration, moisture and dust.
• Do not expose the device to extreme temperatures or humidity.
Note:
If the device is powered by an adapter, only use the AC adapter and power cord
included with the device. Do not use defective sockets. Make sure the cord is properly
plugged into the socket. If the cord is loose, an electric arc can cause fire. Refer to
aqualified electrician to replace sockets.
Note:
Plug the device into aproperly grounded sockets with protective grounding pin only.
Note:
If you plan to mount the device to awall or ceiling, follow the instructions of the
manufacturer and the user's manual for the given system.
SLE SLE 2464TCS + SLE 3258TCS EN+CZ+SK+HU+PL.indb 4 08.09.2016 0:57:26
To Next Page
Loading...
