Sencor SMW 5220 - Grounding and Interference; Grounding Instructions

Microwave Oven
SMW 5220
18. IMPORTANT - kitchenware and aids which must not be used in the microwave oven:
- metal pans or dishes with metal handles or metal trimming
- clips for plastic bags
- dishes with melamine surface
- common thermometers which are used e.g. to measure the temperature of meat, etc.
SAFETY MEASURES TO PREVENT THE POSSIBLE RISK OF EXPOSURE TO
MICROWAVE ENERGY
11. Do not attempt to operate the microwave oven with the door open - you could expose yourself to
harmful microwaves. It is important not to defect or tamper with the safety interlocks.
2. Do not place any object between the oven front part and the door or allow soil or cleaner residue
to accumulate on sealing surfaces.
3. Do not operate the oven if it is damaged. It is particularly important to close the oven door properly
in order to avoid damaging the following parts:
a. door (bent),
b. hinges and latches (broken or loosenea),
c. door seals and other parts
4. The microwave oven may only be adjusted or repaired by a qualified service agent.
GROUNDING INSTRUCTIONS
This microwave oven must be grounded. The oven is equipped with a power cord having a grounding
wire with a grounding plug. The plug must be connected to the electric power point which is correctly
installed and grounded. In the event of an electrical short-circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current. It is recommended to connect the oven to
a separate electrical circuit. Using high voltage is dangerous and may cause fire or different accident
resulting in damage to the oven.
WARNING!
Incorrect grounding socket can lead to the risk of electric shock.
Note:
1. If you have any questions concerning the grounding or electrical instructions, consult them with
a qualified electrician or service agent.
2. Neither the manufacturer or dealer is responsible for any damages to the oven or physical injuries
incurred by the negligence to adhere to the correct electrical connection procedures.
RADIO INTERFERENCE
When using the oven, your radio, television or similar equipment may be disturbed.
In case of interference, it may be reduced or eliminated by taking the following procedures:
1. Maintain the door and the sealing of the oven surface clean.
2. Redirect the radio or television antenna receiver.
3. Move the microwave oven further from the receiver.
4. Plug the microwave oven to a different socket with an independent electrical circuit.
EN-4
Copyright O 2012, Fast CR, a.s Revision 06/2012