Sencor SMW 5220 - Installation

Microwave Oven
SMW 5220
INSTALLATION
N
10.
11.
Make sure all the packing materials, such as plastic bags, polystyrene etc., are removed from the
inside of the oven.
WARNING: Check the oven for any damage, such as misaligned or bent door, damaged door seals
and sealing surface, broken or loose door hinges and latches and dents inside the cavity or on the
door. In case of any damage, do not operate the oven and contact a qualified servise agent.
The microwave oven must be placed on a flat, stable surface to hold its weight and the heaviest
food likely to be cooked in the oven.
Do not place the oven where heat, moisture or higher humidity is generated, or near combustible
materials.
To ensure the correct operation, the oven must have sufficient air flow. Keep 20 cm free space
above the oven, 10 cm at back and 5 cm at both sides. Do not cover or block any events of the oven.
Do not remove the oven's feet.
Your product has been designed for use as a stand-alone device. It has not been designed to be
used as a built-in appliance.
Do not operate the oven without installing the glass tray, the roller ring and power device.
Never place the glass tray upside down. The glass tray should never be restricted. If glass tray or
turntable ring assembly cracks or breaks, contact your nearest seller or authorized service center.
All food and containers of food are always placed on the glass tray for cooking.
Make sure the supply cord is not damaged, placed under the oven or in contact with any hot or
sharp surface.
Make sure that the electric power socket is easy to reach in case of a quick disconnection of the
power cord out of the socket.
Do not use the oven outdoors.
EN-5
Copyright © 2012, Fast ČR, a.s. Revision 06/2012