EN-8
EN
Steam Iron
SSI 8440GR / SSI 8441VT
05/2019
2019
2. Setting the temperature control dial
• Ensure that the iron is located in a vertical position on an even stable surface.
• Connect the power cord to an el. power socket.
• Set temperature control dial A10 based on the fabric type you wish to iron. A lit indicator light A9
signals that the ironing surface is heating up. As soon as the ironing surface heats up to the set
temperature, the indicator light A9 will turn off.
Note:
During first use a weak cracking sound caused by the expanding plastic may be heard. This
is an entirely normal event, which will disappear in a short time. While ironing the indicator
light A9 will intermittently turn on and off. This indicates that the set temperature is being
maintained.
First iron the laundry that requires the lowest temperature. This will save you time because
the iron heats up faster than it cools down. If you are ironing at a high temperature and then
set a lower temperature, wait until the iron cools down.
3. Steam
• Only use the steam function when the temperature control dial A10 is set to a temperature of
• • • to MAX. Use the control dial A5 to set the desired steam output. Turn the control dial A5
anticlockwise to continuously increase the steam output. Turn the control dial A5 clockwise to
continuously decrease the steam output.
Note:
The iron continuously emits steam only if you hold it in a horizontal position. Stop the release
of steam by standing the iron upright in a vertical position or by turning the output steam
regulator A5 to the minimum level.
DRIP-STOP FUNCTION
• This function automatically stops the steaming process if the temperature control dial is set to
a temperature that is too low and so prevents water from dripping from the openings.
FUNCTION OF THE STEAM IMPULSE
• Press the steam impulse button A3 to generate a strong flow of steam which can even out even
very crumpled up textiles.
• Only use the steam impulse function when the temperature control dial A10 is set to a temperature
of • • • to MAX. If indicator light A9 turns on, wait until it turns off and only then press the steam
impulse button A3. Wait several seconds before pressing the button again.
• The steam impulse function A3 can be used when ironing textiles (e.g. curtains, hanging clothes,
etc.) in the vertical position.
SPRAYING FUNCTION
• The spraying function can be used when the temperature control dial A10 is set to any temperature.
Ensure that there is water in the tank A12 and to dampen the textile press the spray button A4.
Note:
Do not use the spraying function on silk and synthetics.
DRY IRONING
• If you want to iron without steam, follow the instructions in chapter Steam ironing, point 2. Setting
the temperature control dial. Set the regulator A5 to the minimum level.
To Next Page
Loading...
