EasyManua.ls Logo

SENDO Advance - Taking Measurements; Measurement Procedure

SENDO Advance
17 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Measurements
SENDO Advance is designed to detect the pulse and to inate the cu to a systolic
pressure level automatically.
If your systolic pressure is expected to exceed 230 mmHg, read
"Measurement with the Desired Systolic Pressure" on the next page.
Sit comfortably in a chair with your
feet at on the oor. Place your left
arm on a table at a slight angle.
Wrap the cu around the upper
arm, about 2 - 3 cm above the
elbow, as shown.
Place the cu directly against
the skin, as clothing may
cause a faint pulse and result
in a measurement error.
Constriction of the upper
arm, caused by rolling up a
shirtsleeve, may prevent
accurate readings.
Conrm that the index
points within the proper t
range.
1
2
Arm Cu
Index Mark and Proper t range
Air Hose
2-3 cm
4