Sendum PT300D - Turn on Your PT300 D

PT300D QuickStart Guide
Part Number BFA10083 - Verizon
-- 5 --
Sensor Pack
AC Adapter
Data Cable
PT300D
Command
Module
PT300D
Command
Module
Sensor Pack with
sufficient battery charge
PT300D
Command
Module
Accessory Pack
10K mAh Battery Pack
with sucient charge
Figure 6 - Turning the PT300D on by connecting it
with a charged Sensor Pack
Figure 7 - Turning the PT300D on by connecting it
with a Sensor Pack being charged
Figure 8 - Turning the PT300D on by connecting it
with an Accessory Pack and a charged
10K mAH Battery Pack
Appendix
1. Turning on your PT300D
You can turn on (i.e. power up) your PT300D by
connecting the command module to a Sensor
or Accessory Pack.
To make the connection, simply push the
command module into the pack until you hear
a click sound. Once connected, ensure the
Charger LED is ON. The color will be either red
or green.
When connecting any type of Sensor
or Accessory Pack to the Command
Module, always make sure the
connection is solid and that you hear
the confirming “Click” sound.