Senix BLVE12-M - Assembly; Assemble as a Blower; Assemble as a Vacuum;Mulcher

7WWW.SENIXTOOLS.COM
ASSEMBLY
WARNING:
Read the ENTIRE IMPORTANT SAFETY
INFORMATION section at the beginning of this manual
including all text under subheading therein before set up
or use of this product.
ASSEMBLE AS A BLOWER
ASSEMBLE AS A VACUUM/MULCHER
1. Slide the blower tube forward until the notched area
on the blower housing clicks into the slot on the
blower tube.
2. Insert the concentrator nozzle onto the end of the
blower tube until it locks into position (Fig. 1).
1. Slide the front and rear vacuum/mulcher tubes
together until the lock button engages (Fig. 5).
NOTE: The concentrator nozzle is used to increase air
ow in tight areas (i.e around ower beds, under decks,
etc.).
3. Before using the blower function, rotate the lock knob
to lock the cover in place(The indicator will be on the
far right position,Fig. 2).
4. To remove the blower tube, turn the ON/OFF power
switch to the OFF (O) position and disconnect the
tool from the power supply (Fig. 3).
5. Press the tube release button and remove the blower
tube (Fig. 4).
ON
OFF
Notched area
Concentrator
nozzle
Air outlet
Blower tube
Fig. 1
Lock knob
Fig. 2
Fig. 3
Tube release button
Fig. 4
Fig. 5
Rear tube
Front tube