EN - 4 WWW.SENIXTOOLS.COM
Direction of fall
Notch
50 mm
Felling back cu
Hinge
50 mm
Keep work off ground. Leave support limbs until log is cut.
Log supported along the entire length
Cut from top (overbuck). Avoid cutting earth.
Bucking a log
Stand on uphill side when cutting because log may roll
2nd cut overbuck (2/3 diameter)
to meet 1st cut (to avoid pinching)
1st cut underbuck
(1/3 diameter)
to avoid splintering
Log supported one end
2nd cut underbuck (2/3 diameter)
to meet 1st cut (to avoid pinching)
Log supported both ends
1st cut overbuck (1/3 diameter)
to avoid splintering
10
11
12
13
1514
To Next Page
Loading...
