Need help?Do you have a question about the Senix Ultrasonic Sensor and is the answer not in the manual?
Records changes made to the product documentation over time.
Details the terms and conditions for product repair or replacement.
Explains the basic principle of ultrasonic sensor operation.
Lists the benefits and features of using ultrasonic sensors.
Provides examples of how the ultrasonic sensor can be used.
Lists the components included in the product package for initial setup.
Details the technical parameters and capabilities of the sensor and circuit board.
Provides instructions on how to physically install the ultrasonic transducer.
Explains the proper grounding procedures for metal surfaces.
Describes the mounting pattern for the main circuit board.
Advises on the correct positioning of the transducer relative to the target.
Details how to connect the transducer, power, and RS-232 interface.
Specifies the voltage and current requirements for powering the sensor.
Explains the serial data format and connection for RS-232 communication.
Outlines the steps to initiate sensor operation after installation.
Explains how to interpret the sensor's output data to determine distance.
Describes the provided QuickBasic program for data acquisition and display.
Specifies how frequently the sensor takes measurements and outputs data.
Discusses factors affecting sensor performance based on target properties.
Explains how temperature variations impact measurement accuracy.
Lists important safety and operational guidelines to follow.
Guides on how to fine-tune sensor sensitivity and tuning parameters.
Provides initial troubleshooting steps to verify sensor functionality.
Lists typical issues encountered and their potential solutions.
Offers contact information for technical support and return procedures.
General| Brand | Senix |
|---|---|
| Model | Ultrasonic Sensor |
| Category | Accessories |
| Language | English |
To Next Page