Sennheiser ASA 214 - User Manual

Installing the ASA 214
52
Installing the ASA 214
These sections contain detailed information about installing and starting
up the ASA 214.
You can find information about operating the ASA 214 under “Using the
ASA 214”.
Connectors on the rear of the device
Product overview for the rear side of the ASA 214
►
1 ANT RF IN B BNC socket
• Antenna input of diversity branch B
• See “Connecting antennas”
2 RF OUT A BNC socket
• RF output only for connecting an additional ASA 214 to build an 8-
channel diversity system
• See “Configuring multi-channel systems”
3 DC INsocket
• To connect the NT 1-1 power supply unit
• See “Connecting/disconnecting the ASA 214 to/from the power sup-
ply system”
4 4 BNC sockets B1 to B4
• RF outputs of diversity branch B for connection to the receiver
• See “Connecting receivers to the ASA 214”
5 ANT RF IN A BNC socket
• Antenna input of diversity branch A
• See “Connecting antennas”

Summary

Connectors on the rear of the device

ANT RF IN B BNC socket

Antenna input for diversity branch B.

RF OUT A BNC socket

DC IN socket

Connection point for the NT 1-1 power supply.

4 BNC sockets B1 to B4

RF outputs for diversity branch B to receivers.

ANT RF IN A BNC socket

Antenna input for diversity branch A.

4 BNC sockets A1 to A4

RF outputs for diversity branch A to receivers.

Connecting;disconnecting the ASA 214 to;from the power supply system

Connecting receivers to the ASA 214

Connecting antennas

Connecting remote antennas

Connecting rod antennas

Configuring multi-channel systems

Installing the ASA 214 in a rack

Mounting a single antenna splitter in a rack

Mounting two antenna splitters side by side in a rack

Using the ASA 214

Operating elements on the front of the device

Switching the ASA 214 on and off

Specifications

Sennheiser ASA 214 Specifications